FS - 1997 Suzuki LS650. Parts ...
(List updated, 8/11/15)
NOTICE, PRICES CHANGED !!!!
It had only 5600 miles on it, and it ALL, is in Exc Shape.
(Except the Motor), That's why the parting out.
Everything Worked, and these parts are ALL, Factory Parts.
(Found out what was the problem,
Opps, to late now, it is stripped down, my loss, is your gain)
(Notice: Their may be photos of a ‘group’ of parts, some in that group, may be sold.
If a photo is of ‘one’ part. it is most likely still avaibiale.
The, ‘list’, of parts, is what is updated.
As things sell or change, I will update. Keep Checking,
Prices change, when a part is sold off, of a, 'assembly'.
Cash & Pick up, or if shipping, you pay shipping,
and Postal, M.O. Payment
Most small things can go in the 'one rate' P.M. Box.
Small is a VCR sized box, 6.00
Med is 12.65, (13x12x3.5 “) or (11x8x5 “)
Large is 17.65. (12x12x5.5”)
(And that is up to 65 pounds per box in Med & Large)
Larger things, check shipping, coming from zip code, 55360
(Don’t forget Greyhound Bus)
Rear Foot Rests Complete parts. $35.00 Set of 2
Rear Wheel Complete, w/Rim/Hub/Belt Sprocket/Spokes/Drum/Break Lever/Axel/Spacers $200.00
Or will break down to the 3 basic components; Wheel, rim, tire, w/axle & Bushings; $75.00
Break drum; $25.00
Rear Sprocket w/ drive unit & rubber spacers. $150.00
Front wheel, Rim/Hub/Spokes/Bearings. $125.00
Break disk & Screws, $75.00
Starter Complete $150.00
Front Pulley Front belt pulley 5600 miles Exc Shape, paint hardly off inside splines. $45.00
Carb Complete Mikuni 24C4-H7Y2 $200.00
Spedo Gauge. w//Gear, lights and plug. 55.00
(Spedo shows 5609 but you can ‘spin’ these back and forth)
Front Break Cal COMPLETE, Lever, Cable, Reservoir, Cal. $125.00
Belt cover Top Chrome $30.00
Belt cover Bottom Chrome $20.00
Pulley Drive Cover, Left side, with screws & Spacers. $35.00
Ignition Coil, With Screws & Spacers $45.00
Ignightor Coil, With screws & Bracket (32900-24B10) $150.00
Air Box Complete W/Screws $10.00
Rear Fender, (Red) $40.00
Front fender, (Red) $30.00
Wire Harness Complete, with each plug marked. with some relays, All in Exc shape $100.00
Starter Solenoid W/Cables & Screws $35.00
De-Comp Solenoid, W/ Screws, control unit, Bracket, Cable $100.00
Reg/Retc Voltage regulator/Refectirfier $60.00
Right Switch Start/Kill, w/wires/plugs. $40.00
Clutch Cable, With Lever, Clamp, switch $40.00
Left Switch Blinker.Horn,Hi/Lo & Cable $40.00
L&R Crome Top Engine covers/rubbers/bolts, ( for both) $15.00
Left Front Kickstand/bracket/shift lever. Assembly $65.00
Right Front Bracket/Break lever/ $75.00
Front L & R, Turn Brackets/clamps
(The piece that fits over the forks) (each) $20.00
Bar Risers 1.5" tall (2) $55.00
Handlebar $35.00
Steering Stem Complete (Top & Bottom) $125.00
Forks L&R (each) One, L or R, 200.00 each.
Both, 350.00 for both.
(Both shiny, smooth, not pitted or rusty, with all factory parts)
Oil Pump W/Gear, pin. 30.00
Crank Balancer, W/Gear, Bearings, Bolt Washers. $40.00
Stator 100.00
Rotor 75.00
(Both 150.00)
Transmission Parts, (97 LS-650)
(See Photo) All in photo. $125.00
The two haves of the lower case,
some bearing in place yet. $75.00
Cam Chain, W/ Top & Bottom Sprockets, and slides. 75.00
≠Contact me, via e-mail: outdoor986 (at) yahoo (dot) you know the rest.
or a P.M. via the group that got you here. The above address, I usually check only once a week.
This is what it looked like before I stripped it.
Photo Below: Starter 150.00
Photo below: Stem, both pieces, with bearings. 125.00
Photo Below: Carb 200.00
Photo Below: Forks, 200.00 for one, Both 350.00
Photo below: Disk, 75.00
Photo Below: Front break, all you see. 125.00
Photo below: Front pulley, exc shape, 45.00
Photo below: Rear Pulley/sprocket/rubber, 175.00
Below: Stator/Magneto/Gear
Photo Below: Clutch cover, w/ screws and locating pins; 75.00
Sprocket cover: w/screws/washers; 30.00
Photo Below
Will fit in a Med P.M. Box 12.65 Shipping in the USA.
175.00 total for all the parts shown
Photo Below
Will fit in a Med P.M. Box 12.50 Shipping in the USA.
100.00 with all the parts shown.
(Yellow dots, are just my marks to measure from)
Photo below,
All these parts. Is should be everything, as I took it apart.
Don’t have a clue, how to put it together again,
That’s Your job.
If you want One little piece, let me know, (Perhaps)
If you don’t need all, but at least 1/4 of them.
For 125.00 + 17.65 (shipping in USA my PM Mail)
It is quite a bargain, over one piece at OEM price.
Gas tank, One tinny dent, a scratch, a touched up spot, and a paint chip. (circles)
Some small spots of flash rust on inside. (from sitting)
Gas tank, with OUT, gas cap, and Spedo. WITH, Factory Petcock.
If you are doing to repaint/weld, this is Perfect.
If you want to use as is, a very small amount of, polish touch up, will make it look new.
Was going to keep because of the logo. Now found another place that will reproduce that logo.
200.00 + Shipping.
